View Full Version : cutting holes for an intake?

02-04-2006, 06:11 PM
has anyone ever cut a hole and angled a cone down in a bc? like on the opposite side of the battery, cut about a 6-8 inch hole, put a 90 degree elbow on the pipe, and get some sort of ram air thing going? its probably a stupid idea because water could get in, but i would try to put something under it, or cut a section out of the grille part of the bumper.

02-04-2006, 08:47 PM
cut where, in the base of the engine bay or in the fender?

Cos there's already a hole in the fender.

02-04-2006, 11:42 PM
I submit for you:

This Thread (http://bbs.legacycentral.org/viewtopic.php?t=24776)


This Thread (http://bbs.legacycentral.org/viewtopic.php?t=25129)

both are from LCO. Look in their intake section, theres a goldmine there.