Group N Pitch Stop mount bolt

[ShadowGT]

Something horrifically stupid has occurred to me. It's been a few weeks after installing the Group N motor mounts and pitch stop.
While working in the engine bay today I noticed that the bolt that holds the pitch stop to the motor. Not the firewall side.. the side motor.. is missing.

Fucking Gremlins. I could have never just not torqued that side down enough and the bolt or axle or whatever that was just vibrated loose and backed out. So I blame Gremlins for stealing it. Or the guy with the lame Lancer down the street from me.

Either way.. what would be a suitable replacement? I need like size / length / thread pitch all that.

Thanks

[green97gt]

?? whetever goes thru the hole and had a nut on the other side??

dick around at your local hardware store, youl find somethin.

just need something that fits in the hole, keep it as big as possible.

[ouch1011]

If you have to replace the bolt and nut, then the largest bolt you can fit through the hole will work. Doesn't matter if it is SAE or metric or what thread pitch, as long as the bolt and nut match.

Don't drive the car around too much with that bolt missing, and if you have to drive it, be very gentle.