92 Legacy 20T Haltech

[SubaruAnders]

Hello.

I have a 92 Legacy 20T.
And bought Haltech Platinum Sports 1000 But have a little trouble getting it mapped so everything works.
Does anyone have a Map that I can get, so I can start the car?

Sincerely,
Anders Bjellum Svenskerud

[Robbks]

e-mail
support@haltech.com
they should be able to get you a base-map with correct configuration.
but as for a drivable map. you may need to find a tuner in your area that can give you a base map before taking it to them for a tune

[SubaruAnders]

Hi and thanks for the reply.
I've had a MAP of the Haltech, but it is for WRX 93 And with this I got from him does nothing.
I've posted topic on all forums I can find that with Legacy.

Anders Bjellum Svenskerud

[Robbks]

the 92 Legacy and 93 WRX share the same basic engine and the base map will be enough to get all the correct configurations for the car
but you then need to tune the fuel and ignition maps to be able to drive it.

you can't just "get" a base-map that will be drivable. you need to have it tuned

[SubaruAnders]

Hi
Yes, I know that I need to tune it before it starts. But sensors do not provide the right signals, so there is nothing that works properly. For example, the MAP sensor shows 200 bar. And IAT shows 120 C.

[Robbks]

you will need to check which inputs/ outputs the sensors are wired to and confirm that the software is looking at that correct input/ output for each sensor.

is is a wire-in patch loom or plun-n-play loom?

[SubaruAnders]

Ok. I'll try.
It is Plug 'n the back of the ECU. But all the wires we had to connect the sensors. But is a bit odd, it worked a little while, even tilt it completely.