PDA

View Full Version : Rotors


gero808
08-13-2010, 02:28 PM
I have a 01 legacy Gt limited. I was wondering to remove the rotors do you have to take off the axel nut?
StatGSR
08-13-2010, 03:13 PM
nope
BG5guy
08-13-2010, 03:14 PM
nope, just wheel ( duh) and caliper
ouch1011
08-19-2010, 02:12 AM
Sometimes the rotor will get rusted on the hub and take a little persuasion to get off. Just be careful not to damage the lug studs, or hit the rotor too hard as you can leave divets in it.
Airgne
08-19-2010, 02:19 AM
rubber malet will do the trick.
gero808
09-11-2010, 03:23 AM
nah 8mm bolt to the 2 bolt holes on the rotor pops the rotor right off the hub, thanks guys.
LiCelsior
09-11-2010, 08:13 AM
yep thats what its there for. unless the p/o snapped them off.
BE-Fresh
10-03-2010, 03:07 PM
Ok, i'm doing my rear rotors right as I type this. Hit it multiple times with a rubber mallet, and I still can't get the rotor off. I can pull it out a few mm with my hands, but it seems to "snap" back in place. Is there something i'm missing? I've never had a problem with replacing rotors ever.
decke48
10-03-2010, 04:22 PM
ebrake shoes must be sticking (from rust rings). theres a little rubber plug in the backing plate below the hub you can get a screwdriver in to loosen the adjuster
BE-Fresh
10-03-2010, 06:03 PM
ebrake shoes must be sticking (from rust rings). theres a little rubber plug in the backing plate below the hub you can get a screwdriver in to loosen the adjuster

:smt023 Went out and finally got a Haynes manual, and it told me the same thing...shoulda got one sooner :oops: