Ugly fender liner/bumper gap

[anothernord]

This is what the fender liners look like on my car, and it annoys me more than anything. What can/should I do to close up the gap? Add more fender liner material? Bend stuff?

https://sl-i.net/FORUM/images/imported/2010/08/IMG_0425-1.jpg

[LiCelsior]

u missing the clip? top piece is suppose to go under the fender.

[anothernord]

I have the clip, but it doesn't pull the bumper in toward the liner enough.

[LiCelsior]

wierd, i just clip it on the fender and push the liner inside the fender and its flush.

[Huffer]

Drill + zip tie.

[anothernord]

Drill + zip tie.

:lol: This may be what I resort to. The gap bothers me so much for some reason.

[TheSiege]

I have this same issue, only on the drivers side though

[Navi271]

I thought at first you took a pic of MY car! It's exactly the same as mine, and I've never really minded. It's not doing any harm...

[BG5guy]

just take the liner out, dump your car, and you will never see the inner fender again lol

[harrymaneuvers]

Anybody have any updates on this?


I replaced my drivers side liner because the previous owner/seller cut a hole in it so he could access the bumper bolt inside... which he didnt even use... instead he drove a sheetmetal screw into my fender :smt017


Even after replacing though... I have that same gap on both sides... with the clips installed.


I am annoyed by it too and would love to fix it...


Lets start tossing around ideas besides a drill and zip tie... no offense Huffer.

[anothernord]

Forgot about this thread. I went ahead and did the drill+black zip-ties, and it works perfectly.

[harrymaneuvers]

What did you ziptie it too?


Explain please... do you see any holes or zipties?

[4U2Envy]

I had the same problem after i did my jdm fog install. I ditched the factory hardware and I just used a 25mm long M6 bolt with 2 decent sized washer and a nut, it pulled nice and tight. I'll take a pic tomorrow if needed :smile: