Hell Horns Help - Installed, no sound

[Cervantes]

this is what I used to install them....hope it's right

https://sl-i.net/FORUM/images/imported/2010/08/3496770441_fceba7165b_o-1.jpg

these are the actual horns and wires

https://sl-i.net/FORUM/images/imported/2010/08/IMG_0345-1.jpg

i went by the diagram, but i dont have any sound coming out of the horns. does anyone have pictures of what its supposed to look like once everything is plugged in and hooked up? any help will be greatly appreciated.

[Grafton]

your wireing looks correct, if you have a multi meter check for 12v when the horn is being blown, (relay trigger) that your getting 12v to the relay from the battery, and check your grounds with the multi too

[Airgne]

just use the power wire for the stock horn, and ground to rad support. dont need there relay. there is a relay in the system already.

[Cervantes]

ok, so i hooked it up to the stock power lines and it worked. only issue i ran into is that one of them is too short and won't reach....

[Airgne]

ok, so i hooked it up to the stock power lines and it worked. only issue i ran into is that one of them is too short and won't reach....


butt connecter the extra wire that you need in.

[02_Legacy]

butt connecter the extra wire that you need in.
Make sure you use one with heat shrink, it will probably corrode fast right up front if it is not sealed.