PDA

View Full Version : headlight harness


Wiscon_Mark
02-27-2006, 03:11 PM
can anyone tell me which wire is the high beam? I'm wiring up my driving lights, and I need the high beam to be my relay trigger.
Legacy4Life
02-27-2006, 03:25 PM
Looks like it's the RED wire on both sides.
RED/BLUE on the left is the 12 volt supply and BLK/YELLOW is for the right.
YELLOW/BLUE is for Low Beam on both sides. It also runs through your DRL module if you have one.
Wiscon_Mark
02-27-2006, 03:35 PM
red is what I needed to know, thanks :)
shazapple
02-27-2006, 08:23 PM
Get a multimeter, theyre 30 bucks and a very good investment. Especially when youre working with 100 dollar electrics
Wiscon_Mark
02-27-2006, 08:26 PM
Get a multimeter, theyre 30 bucks and a very good investment. Especially when youre working with 100 dollar electrics

oh , I have one, I just didn't want to hack wires if I didn't have to. I also work alone, so it would be tedious.
Legacy4Life
02-28-2006, 06:07 AM
An easy way to get a reading on a wire that is still shielded and which you don't want to "hack" away, is to use a tiny sewing pin. It will prick through into the core and not leave a hole afterwards. I use that trick all the time.

Just make sure your pin doesn't touch the chassis though!