Got a replacement cat question...

[1-3-2-4]

I got a bosal replacement 2nd cat anyways I haven't put it on yet but I was trying to see if my dealer gasket (44011AC000) would fit and it does not on the end that goes from the cat to the center pipe it's like the gasket is like 2 mm too thick ti fit over the pipe of the converter.

here is a shot

https://sl-i.net/FORUM/images/imported/2011/02/IMAG0127-1.jpg

So I've know i looked at NASIOC and someone else had the same issue but what should I do?

[1-3-2-4]

no one?

[Reason]

Take measurments and go to a parts place and tell them the size you need.

[Grafton]

^ that's what i did to get a gasket for my obx "cat" pipe

[1-3-2-4]

Well I hope to have it done sometime this weel

[Reason]

Or bring in the cat. I need to chane my gaskets. I need two different sized donut gaskets to join my stock cat and custom mid pipe. I bring in the old ones and they match them up for me.

[1-3-2-4]

So much for drop in and install lol