STI Exhaust on BH. Need pics please!

[MRLancaster]

If anyone has pics of STI exhaust on the BH wagons, can you take some under car pics, especially at the muffler. Was doing some measurements and this isnt look too good for me on getting it positioned. So was going to see if anyone else has them and where they sit and all that on the car. Thanks!

[Huffer]

It's all about hanger adjustment. Once that's done, then you can extend/shorten the midpipe and rotate the flange.

[MRLancaster]

Yeah the hangers will have to change position. but the is I have is where the tip will end. https://sl-i.net/FORUM/images/imported/2011/05/downsized_0520011658-1.jpg
Thats where the tip will be....
https://sl-i.net/FORUM/images/imported/2011/05/0520011659a-1.jpg
because that green piece of metal is blocking how far the muffler can go.

I dont see how others have the tip come to the bumper

[rougeben83]

the tip will come out downward at a slight angle

[MRLancaster]

Is that why all the BE's and BH's are always facing down??

[MRLancaster]

Problem solved....
Original.

https://sl-i.net/FORUM/images/imported/2011/05/downsized_0521011850-1.jpg

Idea:
https://sl-i.net/FORUM/images/imported/2011/05/downsized_0521011857-1.jpg
Get them to lengthen the pipe the tip is connected to until its at the edge of the bumper. :)

[bobbyjimmy]

I had an STi muffler on my BH a few yrs ago - the exhaust place did what you are going to do, extend the tail pipe.
It'd be pretty close on a BE, but not a BH.

[MRLancaster]

Would you have any pics? Im debating if it will look good or funky looking

[bobbyjimmy]

Nup - it was years ago and in my opinion looked ordinary/dodgy, took it off after a couple of months.

[rougeben83]

The USDM BE/BH rear bumpers were not really made with straight exhaust tips in mind. Your exhaust tip will hang a little lower and/or tilt downwards a little.