PDA

View Full Version : Is this a good deal on an exhaust for my ladies wrx wagon?


harrymaneuvers
06-22-2011, 08:27 PM
Just came across it and it seems like a good deal but I really dont have a clue when it comes to exhaust components.

http://cgi.ebay.com/ebaymotors/JDM-02-0 ... 850wt_1165 (http://cgi.ebay.com/ebaymotors/JDM-02-07-Subaru-Impreza-WRX-STi-GD-Fujitsubo-Exhaust-_W0QQcmdZViewItemQQhashZitem3cb9424267QQitemZ260806165095QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories#ht_2850wt_1165)
Huffer
06-22-2011, 11:53 PM
Not really...
harrymaneuvers
06-23-2011, 12:13 AM
What should I be expecting to pay?

just for a cat back?
Huffer
06-23-2011, 12:36 PM
$200 installed.
httrdd
06-23-2011, 12:48 PM
Not sure if this counts, but I bought my 3" Borla for 50 bucks plus gas(1.5hours each way)!
ouch1011
06-26-2011, 02:33 AM
A quality catback for a WRX will be way over $200.

$500 would be fair for a new one.

$299 isn't bad for a Fujisubo, but IIRC they are quite loud.
grayguy
06-26-2011, 03:08 AM
I am a big fan of cheap eBay exhausts. Both my friend and I ran eBay 3" TBE that was about $300 shipped to my door, and we got A LOT of compliments about the sounds from guys with 5 times the $$$ into their setups.

We both sold the cars and both exhausts and both setups are holding up strong (even after his fell off the hangers and got dragged a few blocks)
Huffer
06-26-2011, 11:17 PM
A quality catback for a WRX will be way over $200.

$500 would be fair for a new one.

$299 isn't bad for a Fujisubo, but IIRC they are quite loud.

Whatever!! Sti axleback mated to a custom midpipe will run $200 tops. Forget the bling systems unless you like wearing overpriced decals.
Reason
06-27-2011, 08:44 AM
That looks to be in real good condition, $300 shipped is worth it to me. I rather have that than the gross stock wrx set up. I looks nice and I bet it will sound nicer too. If I were to sell my custom catback I wouldn't take anything less than $300 for it. That may be a little bit nicer than mine.
Wiscon_Mark
06-27-2011, 10:45 PM
I'll sell you my STi catback system for a lot cheaper (about 18,000 miles on it) once I get a stock system to put on mine...
ouch1011
06-27-2011, 11:16 PM
A quality catback for a WRX will be way over $200.

$500 would be fair for a new one.

$299 isn't bad for a Fujisubo, but IIRC they are quite loud.

Whatever!! Sti axleback mated to a custom midpipe will run $200 tops. Forget the bling systems unless you like wearing overpriced decals.

I was talking about bolt-on stuff, not custom. Prices on custom built systems can range from uber cheap to ungodly expensive, so I wasn't going to go there.