View Full Version : low boost on primary turbo
Cervantes
07-29-2011, 04:04 AM
swapped out my turbos and now i'm only hitting .3 bar. what would be the issue or cause for such low boost? i checked for leaks and didnt find any. could it be a bad actuator?
any help is appreciated!
chuckthefuk
07-29-2011, 12:52 PM
Are you sure your vacuum lines are not mixed, damaged, etc?>
Usually if the wastegate actuator is given improper vacuum lines it will prematurely open or worse it wont open at all.
Have you check:
- T-connectors
- Shaft play on the turbo
- The wastegate section on the hot / cast side of the turbo. They usually crack <-- http://forums.nasioc.com/forums/showthr ... ?t=1477504 (http://forums.nasioc.com/forums/showthread.php?t=1477504)
Cervantes
07-30-2011, 02:36 AM
its going to be such a pain in the ass if it's cracked....
rougeben83
07-30-2011, 10:09 PM
boost leak test the system, you may have a slow leak in the intake tract now that you had to change out parts, common problem...
Cervantes
07-31-2011, 01:58 AM
i checked for codes and got error code 65. from what ive read it is caused by either the zerosport sequential controller i have on the car or the vacuum pressure sensor. where is that located and how can i fix it?
thanks
Reuben
03-26-2012, 05:15 PM
If a turbo is boosting low, due to being broken, you will get errors from the computer that will most certainly send you off in the wrong direction. I simply think if you have only just put the turbo in, that the turbo itself is fucked and to blame.
Could be as simple as a broken wastegate actuator though. :P
Cervantes
04-02-2012, 06:47 AM
wow...this just popped up out of no where. i have had this fixed for a while now lol
chuckthefuk
04-02-2012, 10:06 AM
so what was the problem?
Cervantes
04-02-2012, 05:02 PM
if i remember correctly, it was a combination of the boost controller settings and vacuum hoses not connected properly. no one seems to really know how to setup boost controllers on a twin turbo sequential setup. luckily, i am i damn wizard at it, since i kept having to fix issues myself.
chuckthefuk
04-02-2012, 05:45 PM
if u got time.. write some stuff up like Reuben did.
Lots of UK/OZ/NZ guys on the board looking for info
Cervantes
04-03-2012, 04:51 PM
will do
Powered by vBulletin® Version 4.2.5 Copyright © 2026 vBulletin Solutions Inc. All rights reserved.