Wiscon_Mark
06-07-2012, 11:17 PM
Last winter, when I replaced the rear wheel bearing, the tone wheel broke during reassembly (probably a preexisting crack). Auto shops weren't really open, so we reassembled it without the tone wheel installed. Obviously, this has caused an ABS light & no ABS.
Is there a way to make the ABS control unit forget about this and only read the others?
Ideally, I'd like to have ABS in the winter, with the ability to turn it on & off, as needed. I can deal without it fine, but I've been driving my whole life with ABS, so I'd rather not have a sharp learning curve if I don't have to. Obviously, I know to pump the brakes without ABS to keep from locking into a skid, but knowing & reacting are 2 different things.
Thoughts, ideas, input?
Is there a way to make the ABS control unit forget about this and only read the others?
Ideally, I'd like to have ABS in the winter, with the ability to turn it on & off, as needed. I can deal without it fine, but I've been driving my whole life with ABS, so I'd rather not have a sharp learning curve if I don't have to. Obviously, I know to pump the brakes without ABS to keep from locking into a skid, but knowing & reacting are 2 different things.
Thoughts, ideas, input?