Mirror transplant. Heated into JDM power folding.

[Legacy89]

Can it be done? and has anyone done it?
Is there a DIY on it?

And does anyone have a pinout for the connectors?

I have stock EDM heated mirrors with electric adjustment at the moment.
Trying to install JDM power folding mirrors with electric adjustment, turn signal and hopefully heated glass.

[chuckthefuk]

Here you go
viewtopic.php?f=9&t=23944&hilit=mirror+jdm+heated (https://sl-i.net/FORUM/viewtopic.php?f=9&t=23944&hilit=mirror+jdm+heated)

Not sure about the Pinouts.

You can try the factory service manual for wiring schematics available through my signature or the literature / manual section of SLi.

Good luck

-Chuck

[camroncamera]

Can it be done? and has anyone done it?
Is there a DIY on it?

And does anyone have a pinout for the connectors?

I have stock EDM heated mirrors with electric adjustment at the moment.
Trying to install JDM power folding mirrors with electric adjustment, turn signal and hopefully heated glass.

I recently purchased heated power folding mirrors from the UK. I have yet to install them. Because the pins had to be removed from the connectors in order to disassemble the mirrors from the bases, the seller kindly provided a connector diagram for each wire color. However, the purpose of each wire is not explained. Perhaps these images will be helpful for you nonetheless:

https://sl-i.net/FORUM/images/imported/2012/06/IMG_3496-1.jpg
https://sl-i.net/FORUM/images/imported/2012/06/IMG_3494-1.jpg

[chuckthefuk]

^^^^^^^^^ this guy = awesome

[camroncamera]

^^^^^^^^^ this guy = awesome

Aww shucks... lol

[Legacy89]

Hmmm, have to figure this out the old school way, trial and error.
The adjustment on the mirror works fine, but it seems that it has 3 settings, folded in, fully out and a thing somewhere inbetween, because i can only see the door in half of the mirror.
But i atleast have 2 switches to compare.

[Legacy89]

I have figured it out :D
Gray/Black
Brown/Yellow
Controls the folding part of the mirror, other than those two wires everything in the socket/plug matches up with OEM mirrors.
So that means that these are allready heated i guess.

Just ned a couple of switches 3-way switches. Since the left mirror will go out too far i can't leave the switch in the fold or unfold position. It must be adjusted each time.

The mirrors are on, just need to wire up the turn signal and folding.