flywheels match?

[tnrknght]

I didnt think to visually check and verify this before attempting to put the motor in, I didnt even think about it. Are the flywheels the same size from the phase1 2.2 to the phase2 2.2? I was in the process of dropping in the motor and we keep getting hung up, not sure if its simply the motor mounts getting in the way or if theres a compatability issue, considering it was dark out by the time I had the motor on the hoist thats all I can really go by.

[anothernord]

Yep you're good to go. Swap dat

[tnrknght]

That being said i think im just getting the motor mounts caught on the crossmember.. maybe if i pull it back out and bolt the mounts in place and then drop the motor onto the mounts? (We pulled the motos with the mounts, unbolted the mounts from the car)

[MonstarMotorsports]

just lift the motor up a little bit and shove the motor towards the fire wall hard (pitch mount undone). the mounts will pop right into the holes.

[tnrknght]

Spent a good portion of my day`yesterday finally doing this, definitely sounds a lot easier than it was, and the car being on a slope didnt help any. however the motor is in, I just have to get the fuel rails and wiring harness atached to the intake manifold and drop that on, then go through and fill all the fluids and such and hopefully fire it up!