whats wrong with my clutch?

[subyL92]

Okay...
Last week my clutch went out...
So I got an exedy stage one...
Replaced it on Sunday..
Now its works, no.slippage or anything...
But wen I drive normal shifting below 3k rpm the clutch pedal feels nice with normal pressure, but wen I start goin over 3k rpm the clutch pedal looses all pressure until.it hits 3in ablove the floor...
But the clutch still engages and disengaged with that 3in of pressure..
What's wrong...I bled and still has the problem...
I replaced clutch disc, pressure plate and throwout bearing..

[Grimmrican]

Did u resurface the flywheel? Make sure all ur hoses are plugged in place?

[subyL92]

Yes and yes...

[subyL92]

Someone told me it might be a master or slave cylinder starting to.fail..

[Grimmrican]

Make sure there's no leaks. But seems legit as to what it might be.

[subyL92]

I checked for leaks.and no leaks at all and the master.cylinder resevoir is maintaining the proper fluid level...
It might be the seals in the master or slave that are weak and not strong enough to hold pressure..

[Grimmrican]

:/ best thing to do is go to a junk yard and pick itself up the master and slave. If anything I'd start at the slave

[subyL92]

As I was driving it today...
I starter to hear a little squeeking noise and wen I give the clutch a lil pressure it stops...
What would this be...
And to also note it still loses all pressure at higher rpm and wen its floppy the squeek is still there wen the clutch pedall is stuck half way then wen you hit the point where there is pressure it stops squeeking..