forester ej20t into legacy gt wagon&rhd conv. wiring quest..

[jdmbh6]

So I have a 2000 Legacy GT wagon. I bought a halfcut of a forester with an ej20 single turbo motor. I also bought a bh6 halfcut without the engine. Ive done all of the wiring but I have no spark. I have power to the ecu but due to the lack of wiring diagrams out there im totally stumped. Anyone out there have any input? Both halfcuts were jdm.....

[Asphalt Art]

Most of the wiring diagrams from the same year will be similar with regards to engine configurations. I would start at the coil to see if it has power. If it does, figure out what controls the firing and so forth.

[rkrenicki]

There is no such thing as a BH6.. did you mean a BH5 or perhaps a BH9?

There really is not enough information in your post to figure out what you have done here.. You have a GT wagon of some indeterminate origin that you are trying to put a JDM single turbo EJ20 into. You did not state what ECU you are trying to use. The engine wiring and ecu from the forester would be needed if you have it. The BH wiring is either for a twin turbo or a non-turbo, so it will have limited use as far as the engine is concerned.

Unfortunately, a US market wiring diagram will be of very little use, as JDM engines are quite different from ours. You may have a better time with a General Market diagram (read as European or Australian) as they are generally closer to JDM.