Turbo build Ej22T OBD2

[Baddog]

So I have been talking to Brian over at Iwire. Was going over a couple options with him. But I am now here to find out what my best options would be .

The car is a 95 Legacy L. Looking to build a turbo motor for it. Ej22T 2.35 stroked short block with Phase 1 EJ25D heads and an Ej25D Intake manifold.

However I am wanting to run a WRX ECU for future proofing and tune-ability. I don't think wiring a WRX ECU into a 95 Legacy harness will work for turboing due to the IACV and other sensors.

Or go with a Greddy Emanage and wire into the 95 Legacy ECU and tap into the 25D sensors.

Pretty much I am here asking what would you guys suggest as far as the right combo to make this work with the least amount of issues.

[86bratman]

One of the things I need to get my hands on is an ej18 throttle body. The iacv on them is very similar to the wrx in the way it's set up. It may be possible to combine the two. I haven't found one to try it out. I'm on a similar path with the ecu swap.

[Granny]

Why not just WRX harness swap and run WRX heads on the 22t?