STI pedals... Any help?

[CarlitoQC]

I just bought these with my new shifter. Is there anyone who has already install this set of pedals on his car?

http://img301.imageshack.us/img301/1526/IMG_0004-7.jpg

The only instruction that came with it... can't read that!

http://img301.imageshack.us/img301/6803/IMG_0005-5.jpg

Here's the JDM STI shifter I've bought at the same time :grin:

http://img301.imageshack.us/img301/2578/IMG_0016-3.jpg

It is sitting on the Fidanza short shifter that Mark sold me

http://img301.imageshack.us/img301/7130/IMG_0007-5.jpg

Ok slightly off topic, sorry but I like it a lot!! Any help for the pedals will be more than appreciated!

Thanks,
Carl

[Huffer]

IIRC, you're supposed to just clip them on, mark the holes, and then drill and secure using rust-proof screws/bolts.

[Wiscon_Mark]

You should like the feel of those :D

It's probably the same routine as WRX pedals. You can search for instructions on those @ Nasioc.

[AussieDan]

The WRX instructions won't help you too much, these mount the same way as most aftermarket pedal covers, whereas the WRX covers are replacements for the stock rubber covers.

You should be able to figure out the instructions from the diagrams, but as huffer said it should be a matter of clipping the new pedal covers over the top of your pedals then drilling and putting bolts in the holes at the bottom of the pedals.

[JMoney]

This seems like an old thread but I was looking at putting WRX pedals on my car and found this thread. I hope it helps.
http://www.scoobymods.com/forums/showthread.php?s=&threadid=128