New from Ontario

[bijon440]

Hey everyone! Been searching and lurking for a while, figured it was time to join. I'm from Ontario Canada. I drive a 99 LGT BD. I have big plans for it and I'm sure one day it will all come together. Hope to get some ideas and feedback!

Cheers!

Brandon

[r3v_v3ng3]

Welcome! Share us your plans :) so we can have better input.

[bijon440]

Well, I want to start breaking down the spare 2.2 I have from my last legacy and get the heads decked so I can begin buying parts for a hybrid. 22 heads, 25 block. The bodywork had to be done. Finish installing my JDM fogs and change the cutoff on the JDM projectors this weekend.
Ummmmm...bigger rear sway, front strut brace, and some lowering springs to compliment the koni inserts I installed a few months back...

That's a start hahah. I'd love to head any and all input! Especially about the frankenbuild. This would be my first rebuild.

Thanks!

[Reason]

Welcome to SLi!

If I do my build over, I would do the piston rings and ARP head studs. I used Cometic head gaskets covered with a permatex copper gasket spray, which I would do again.

[bijon440]

Thanks! I was under the impression that ARP didn't make head studs that would accommodate this build. I've seen people use OE 2.2 studs only