Camber bolts for BG rear end

[micro]

Well I now have 2 degrees of negative camber in the rear end of my car after putting on my eibach pro-kit springs. So I need to find some eccentric camber bolts for the rear end. Best I've found gives only 1 deg of change. Anyone know where i could find some that would fit that would give me any more adjustment?

[chuckthefuk]

Whiteline camber bolts are good for +/_ 1.5 degrees.

Have you looked into adjustable top hats (camber plates)?

-Chuck

[doobieinmyscoobie]

doing some digging here but what are the pros and cons between camber bolts vs plates?

[chuckthefuk]

Camber plates are on top the strut allowing the upper section to be pushed in or out.. + / - camber.

Camber bolts are at the bottom of the strut.. allowing the lower section to be pushed in or out .. + / - camber

-Chuck

[jamal]

should be able to get back out under -1.5 just by loosening up the bolts, pulling the top of the upright out, and re-tightening them.

[ouch1011]

Worst case scenario, if you can only get it to -1* camber, you'll be fine. Many cars run less than that stock. I run -1.5 with no tire wear issues. The car will actually handle a bit better if you can dial in around -1* all the way around.