PDA

View Full Version : A picture request


Kraziken
10-23-2007, 08:05 PM
Does anyone have a Whiteline or other brand Rear strut tower for a BD (or BG wagon if they are the same?) installed?

I'm getting a Tein EDFC installed and I just found out that my Cusco Rear strut tower bar doesn't fit over the EDFC motors. I'm hoping a different shaped bar might work.

Thanks
Ken
Huffer
10-23-2007, 08:17 PM
At the risk of sounding stupid, couldn't you just have a welder cut or move the center parts of the bracket?
rougeben83
10-23-2007, 09:58 PM
At the risk of sounding stupid, couldn't you just have a welder cut or move the center parts of the bracket?

Not even a welder, dremel+cut off wheel :)
Kraziken
10-24-2007, 12:29 AM
I haven't had a chance to see it yet in person to see what is exactly rubbing. That thought did come to mind.

The install should be complete tomorrow so I'll have a better idea what I'm up against.
bakergtt
10-24-2007, 11:27 AM
I have a Syms. I could take some pics this weekend for ya if you would like.
Kraziken
10-25-2007, 12:00 AM
I have a Syms. I could take some pics this weekend for ya if you would like.

Ah, SYMS is the one I have, I suspect it is the same. :)

I talked a bit further, and there is a chance there is a part that raise the motors a bit higher, allowing the clearance for the strut bar. Hopefully something will work to let me keep this bar.
bakergtt
10-25-2007, 10:54 AM
I dont know if you can do this but I did it on my front, if you mount it backwards (if you can) will they fit?