View Full Version : Release/Throwout bearing for tranny snout fix?

11-02-2007, 08:27 AM
There's a sticky at the top of the page for a tranny snout fix and a special throwout bearing that it uses (larger center bore). does anyone know what the part number if this throwout/release bearing is and where to get it?

I posted in the sticky thread, but I don't think anyone reads it unless they are having that problem.

11-02-2007, 12:05 PM
Did you try looking?


11-02-2007, 12:18 PM
did you read my post?

I wanna know what throwout/release bearing is in the kit. I know where to get the whole kit, but I don't want the whole kit, I just need the throwout bearing.

11-02-2007, 12:33 PM
ahhh... I found it. there's a sticker that comes with the kit and on it are the replacement part numbers. I found a site that had teh picture large enough where I could read the part numbers off it.

Replacement numbers are BCA (Beck Arnley/National) 614-147 (pretty sure this is a Timkin number too. or NACHI #60scrn31t

They are for late 80's/early 90's Toyota trucks and 3SGT equipped vehicles.

11-02-2007, 01:09 PM
Like I said did you try looking?