Anybody know anything about this?

[HotBoxer]

http://cgi.ebay.com/ebaymotors/JDM-Suba ... dZViewItem (http://cgi.ebay.com/ebaymotors/JDM-Subaru-Legacy-BD5-Fiberglass-Red-Hood_W0QQitemZ110194184686QQihZ001QQcategoryZ33646QQssPageNameZWDVWQQrdZ1QQcmdZViewItem)

was thinking about this but not sure about where it came from.

[Reason]

I was going to buy it the last auction BUT I'm weary on if it will fit correctly. Also with the lighter hood you usually want to install hood pins, I'm all set with that. Then theres the price to ship it too my house, way too many cons for me.

[HotBoxer]

thats what i was thinking. It says JDM but we all know how ebay is. like the "JDM" stainless fender bolts. THe shipping isnt the issue for me, its spending that much money on something that might not even fit. When I installed my STi carbon strut bar the hood had to be clearanced with a hammer to make it fit. I dont think i could do that with fiberglass. thanks shane.

[Reason]

No problem, It would be an interesting piece to own (if it fit properly).

[dodik]

i saw that hood also those guys also have an aluminum hood and few jdm bumper covers and as far as i know their parts are jdm never purchased anything from them but looking at their inventory kinda says JDM all over it.

[blueb3]

jhot is pretty good, they will answer your questions, and even measure parts for you :) I got my jdm fogs from them, and they were even better than they looked on the auction.

[Reason]

The JDM OEM hood would fit, because it's OEM. But the fiberglass hood is not. It's aftermarket parts, and we all know most aftermarket parts don't fit 100% correct.

[2.5GT]

Does that bottom scoop looks cut off or what? looks like they used a dremel to cut it :lol: