This didn't feel very good (tranny problem?)

[shizznats]

i think i might have a problem with my tranny.. see what you guys can make of this: one morning i pull away in 1st gear and when i depress the clutch to shift to 2nd, i hear a thud and i feel it as well, and then 2nd gear wouldnt go in. that happened a few times n then it was fine for the rest of the ride. the next day, i pulled away from a red light and went to about 6000 rpm and when i hit the clutch, same loud clunk... i was afraid to even try throwin 2nd gear in. any idea what this could be? it happens rarely, but im concerned about it.

[Sarra]

Um, let off the gas so you maintain speed, then depress the clutch. Works on mine.

Lucky you with your fancy 6,000 RPM redline. :evil:

[blueb3]

Not sure. But definately not a good thing. How long since the clutch was last replaced?

[shizznats]

Um, let off the gas so you maintain speed, then depress the clutch. Works on mine.

Lucky you with your fancy 6,000 RPM redline. :evil:

dont all N/A BDs have a 6500 RPM redline??

clutch was replaced about 10000 miles ago at a professional shop. i had an exedy stage 1 clutch installed along with an ACT streetlight flywheel and a clutch kit thing for subaru transmissions.

[Sarra]

Um, let off the gas so you maintain speed, then depress the clutch. Works on mine.

Lucky you with your fancy 6,000 RPM redline. :evil:

dont all N/A BDs have a 6500 RPM redline??

clutch was replaced about 10000 miles ago at a professional shop. i had an exedy stage 1 clutch installed along with an ACT streetlight flywheel and a clutch kit thing for subaru transmissions.

Not when the fucking ECU freaks out and goes into limp mode.

I dunno what to say about the shudder thing. Mine does it if I don't coordinate the clutch and gas just right, but it sounds like your car is doing something else.

[StatGSR]

hows your clutch fluid levels?

[jey]

dont all N/A BDs have a 6500 RPM redline??


My 2.2's at 6200 rpm.