High Beams on with Low beam

[4n70n1n0]

Hey everyone,
I was wondering how can I wire my low beams to stay on when I turn my high beams on. I have JDM projectors and I would like to keep my projectors on when I turn my high beams on

THANKS

[1-3-2-4]

search in the DIY

[rougeben83]

Ground your lowbeams independently (ie direct to chassis). At least on BE's and WRX's the headlight uses ground for the switch.

[4n70n1n0]

Ground your lowbeams independently (ie direct to chassis). At least on BE's and WRX's the headlight uses ground for the switch.

Does anyone know if this works for the BD?


search in the DIY

I did and I didn't find anything. That's why I posted here.

[decke48]

get a signal wire from the high beam switch hook that to the lower power b+ on a relay ground the other side a good body ground. hard wire the b+ for the high side of the relay to the battery through a 15amp fuse. hook the b- (from the high side of the relay) to the low beam wire harness. ground the low beam bulb direct to the frame. you can but in a switch if you like to toggle it just hook into the signal wire before the relay. *just a quick write up*