How to adjust JDM projector headlights...

[shizznats]

This is a question for anyone who has tried adjusting their JDM projector headlights: I tried adjusting my high beams yesterday becaues one of them was just pointing into the ground and i was able to raise it, but the light coming out of my left high beam is much more dispersed than my right high beam, which is more of a focused beam of light. also, there are 2 adjusting screws for the high beam, but both appear to control the height of the beam... what is each of those for?? Thanks

[Huffer]

Up down and left right.

[1-3-2-4]

I can't figure out which one controls the left/right for the high beams.

[02_Legacy]

I can't figure out which one controls the left/right for the high beams.
I don't know if this applies to any other years, but third gens only have an up/down adjustment as far as I know.

[ouch1011]

There is definitely up/down and left/right for the low beams. I don't think there is a separate adjustment for the high beams.

If the light pattern coming out of the light isn't right and the aim isn't right either, I'd check to make sure the bulb is installed properly.

[1-3-2-4]

Ah ok I think I'm going to lower the high beams a bit more but they are kinda useless with HID's I only turn them on when it snows to get more contrast or like last year I ran with them on to make myself more visible.