HeresMyMind
09-12-2008, 10:01 PM
I was getting agitated with having pink gauges and green buttons. so today at work. I actually did some work. with a hot pink sharpe, a swiss army knife. and 8 hours of time to kill. i managed to make my defroster, cruise control, and fog buttons to all match my pink gauges. heres a basic write up:
pop your main dash section out with the 4 screws.
pop each button out of the gauge cluster surround.
when u disassemble the buttons you will need a pocket knife or razor or thin flat head screw driver.
Looking at them sideways ull see there is a brown and a white half. and two lil tabs on top and bottom. if u put the screw driver between them. and push them apart they turn into a bunch of lil pieces
https://sl-i.net/FORUM/images/imported/2008/09/102jkif-1.jpg
first thing i did was color the 2 tiny bulbs with the pink sharpe.
next take the flat head screw driver and poke from behind the main button towards the front of the button and the little symbol that lights up, will pop out.
https://sl-i.net/FORUM/images/imported/2008/09/pozt2-1.jpg
on the back of the little light up thing there is a green gel covering the back. with either a knife or sand paper. scratch it off. and than color it with the sharpe
https://sl-i.net/FORUM/images/imported/2008/09/2iqilmq-1.jpg
reassemble and BWAMO , all set. I wil do the heater conterol buttons when i get a chance.
day shot right after i did them:
https://sl-i.net/FORUM/images/imported/2008/09/29f456p-1.jpg
night shot
https://sl-i.net/FORUM/images/imported/2008/09/9s6m9z-1.jpg
-B
pop your main dash section out with the 4 screws.
pop each button out of the gauge cluster surround.
when u disassemble the buttons you will need a pocket knife or razor or thin flat head screw driver.
Looking at them sideways ull see there is a brown and a white half. and two lil tabs on top and bottom. if u put the screw driver between them. and push them apart they turn into a bunch of lil pieces
https://sl-i.net/FORUM/images/imported/2008/09/102jkif-1.jpg
first thing i did was color the 2 tiny bulbs with the pink sharpe.
next take the flat head screw driver and poke from behind the main button towards the front of the button and the little symbol that lights up, will pop out.
https://sl-i.net/FORUM/images/imported/2008/09/pozt2-1.jpg
on the back of the little light up thing there is a green gel covering the back. with either a knife or sand paper. scratch it off. and than color it with the sharpe
https://sl-i.net/FORUM/images/imported/2008/09/2iqilmq-1.jpg
reassemble and BWAMO , all set. I wil do the heater conterol buttons when i get a chance.
day shot right after i did them:
https://sl-i.net/FORUM/images/imported/2008/09/29f456p-1.jpg
night shot
https://sl-i.net/FORUM/images/imported/2008/09/9s6m9z-1.jpg
-B