crank pulley instal?

[ScaryFatKidGT]

so i got every thing on im 90% sure the key is in the pulley correctly but...

how do u tighten it back down/stop the engine from turning

the DIY said something about the tourqe converter cap housing thing but that was on a 2002 i cant find it on my 98

[Perdue]

should be back on the rear of the block where it meets the transmission almost directly under the throttle body. Start your motor and look under there for movement with a flashlight or whatever. Should be easy as pie to spot then...or is it easy as cake? Brownies even?

[decke48]

if you looking at the TB it down to the left it look for a rubber cap/gromet

[ScaryFatKidGT]

ok and u just like stick a bar or something in there

[Huffer]

Flathead screwdriver, get someone to hold it.

[impreza_GC8]

Is this only for automatics? I used some bigass clamps when did mine and wedged a screwdriver somewhere on the front side of the bock but it would've been nice if there was a better way.

[decke48]

i think the manual have the access to. but ive never botherd to look. so i could be wrong

[subba]

if its a M/T

put it in 5th gear and have someone press on the brakes?

[ScaryFatKidGT]

You can do it on a MT or AT but as subba said in a MT u just put it in gear. In a AT like mine u cant put it in gear with out starting it

[ScaryFatKidGT]

thx for the help i got it on