Front End Links

[rudgers73]

I see Perrin has some front end links for sale in the refurb section. It doesn't say anything about model or chassis code. Will these fit on my BD? Are they universal in Subaru's?

http://www.perrinperformance.com/produc ... ategory=38 (http://www.perrinperformance.com/products/show/711/Front-Endlinks-Subaru-GARAGE-SALE?category=38)

[rougeben83]

those are for a turbo model, so I don't think so.

[decke48]

all the I type links are the same. they made different ones but all fits each other (skinny top or wide top)

[jamal]

That link won't come with any spacers to fit in the u-bracket on the control arm, plus the through hole in the link is M10 where the stock lower bolt is M8.

We need front endlinks that are WRX wagon specific.

Kartboys cost that much and won't start clunking like spherical bearing do. I've had my kartboy endlinks for like 3 years now with no problems.

[impreza_GC8]

$97 for used endlinks is a ripoff. You can get new ones for that much. The Perrin links have always been expensive because they carry the Perrin logo, not because they perform better than Whiteline or Kartboy enlinks.

[rougeben83]

and I wouldn't run spherical bearings unless you really have to to begin with. The poly bushings are much better in terms of reliability.

[rudgers73]

Thanks for the replies everyone. I picked up a pair of front and back from kartboy with poly bushings for $200. Can't wait to get them installed.

[Bdubs]

Good choice, you won't be disappointed.