Blinking Light

[Airgne]

ok so got a free 1st and i have some questions on the 4eat in it. the power light flashes when starting the car. is this normal? also get a shutter while turning. is this a drain and flush fix?

[decke48]

shutting in turns is mostlikely solinoid c. which contols the center diff. its a common problem with early 90's 4eat
memory codes
1 If possible, drive the vehicle above 20km/h until transmission reaches operating temperature.
2 With ignition ON and engine OFF place gear selector into position 1.
3 Turn hold switch ON.
4 Cycle the ignition switch OFF-ON
5 Move gear selector into position 2 and turn the hold switch OFF.
6 Move gear selector into position 3 and turn the hold switch ON.
7 Move gear selector into "Drive" and turn the hold switch OFF.
8 Depress the throttle pedal and release.
9 The power light should be flashing
present
1 If possible, drive the vehicle above 20km/h until transmission reaches operating temperature.
2 With ignition ON and engine OFF place transmission into "Drive" and turn the hold switch ON.
3 Cycle the ignition switch OFF-ON
4 Move gear selector into position 3 and turn the hold switch OFF.
5 Move gear selector into position 2 and turn the hold switch ON.
6 Move gear selector into position 1 and turn the hold switch OFF.
7 Depress the throttle pedal and release.
8 The power light should be flashing.
note jay. they're different ways to get the codes

[Airgne]

and all that will do what?

[jey]

Allow you to read the error code(s) for the tranny by observing the power light.

[Airgne]

so count the blinks and go to the book and read.