PDA

View Full Version : question rebuilding engine


boxingfanatic
05-27-2009, 08:08 PM
Hey everyone... cliff note:
-rebuild head w/ new head gasket
-block clean and checked
-changing clutch and flywheel
-need o pull engine and tranny together
-eveyrthing disconnected including drive shaft
-problem is front axles
-how do i disconnect it from tranny without removing it completely?
decke48
05-27-2009, 11:04 PM
to get the front axles off, you need to punch out the pins holding it to the stubs. then you can pull them off by pushing the tranny to the side and can leave them hanging
boxingfanatic
05-29-2009, 08:05 AM
to get the front axles off, you need to punch out the pins holding it to the stubs. then you can pull them off by pushing the tranny to the side and can leave them hanging

so i can do this while the hub and everything is on right? thanks bro