5x100 bolt pattern to 5x114.3

[--Rogue--]

Would this be a hard DIY job to do? Or is it even possible without bringing it to a shop.

[Huffer]

To do it right you have to swap hubs and axles and diffs...not impossible just time consuming. You will also have to alter your suspension mounting points.

[r3v_v3ng3]

or you can buy the adapter but the shortest ive seen them is 25mm or about an inch

[Huffer]

^ adaptors are junk. Do it right or pay later.

[StatGSR]

i guess im mostly curious as to the why of this question?

[Huffer]

Upgrade to the beefier 06+ STi wheel hubs & drivetrain. It also gets you some arguably better wheel selections.

[StatGSR]

^ i was asking the OP Huffer, not you ;)

[jdmg3]

I am doing this on My 97 Leg Out. right now.

5x114.3 06 STI spindles and fr. struts, Tribeca front rotor with 300zx 4 pot calipers, rear gravel rotor with 300zx 2 pot calipers, ss lines and all of this under a 16 in wheel.

[d1giPhux]

You should make a DIY thread!

[jdmg3]

I will eventually. I am taking pictures right now and I will make a DIY thread once done!