98 2.5 gt 4EAT components ; engine compartment

[N1446]

when facing the engine from the front of the car
on the passenger front strut well there is a bracket with four components attached
two are running tubes into each other - and then to the manifold - ; and two lower rectangular components are simply electrical - what are the two lower electrical components ?

far as i m able to tell , in the same place on a turbo car there are also the two with tubes running into each other and to the manifold , though in place of the electrical components is a boost controler with pvc lines instead > :neutral:
-

[Huffer]

A picture might help, here's one of mine:
https://sl-i.net/FORUM/images/imported/2009/07/FactoryEngineBay-1.jpg

[N1446]

tucked right behind the upper airbox - attached to the tower wall is where the four components are

i m going from turbo -N/A and i m not sure what the additional electrical components on the bracket are for

[N1446]

anyone able to shed some light ?

[jey]

I would guess those are components specific to the turbo motor. None of the BD/BG/BKs have anything other than the MAP sensor and the Pressure Sources Switching Solenoid Valve at the location are referring to, the two things connected to vaccuum lines.

[N1446]

for lack of a working camera here is the bracket , item 3 & 4 are what i am unsure about from the BK EJ25 engine room , I will try and get a pic up shortly

https://sl-i.net/FORUM/images/imported/2009/07/brack-1.jpg

[massdrewski]

<---downloading the service manual. Will post once I find out. Bumpity

[chuckthefuk]

I think this is what your talking about

http://img24.imageshack.us/img24/7071/boxlih.jpg

Taken from Subaru Legacy 1998.zip\
-->Service Manual\DIAGNOSTICS SECTION\ON-BOARD DIAGNOSTICS II SYSTEM\MSA5TCD98L21313.pdf

-Chuck

[N1446]

yeah ,, i tried the service manual as well and i m unable to find anything about the two lower aluminum components - i got some pics yesterday
https://sl-i.net/FORUM/images/imported/2009/07/DSCN0182-1.jpg
https://sl-i.net/FORUM/images/imported/2009/07/DSCN0181-1.jpg

[massdrewski]

so there are two braided cords coming out from it. If anything I would contact a Dealership (west coast?) and email them the picture and ask if their parts dept can help you. I have had a service dept email me half of their Schematics one night while working on the car. put the lap top on the intake and my friend worked from there. Most dealership have really great service/parts depts. at least you have a picture!

[green97gt]

yeah...mine does not have this, so i assume your workin on a turbo car?

what is that red/orange piece in the bottom right hand of one of those pics, where does it go?

are those wires or hoses? other?

[N1446]

not turbo , this part is directly off a 98 lego wagon 2.5 GT

the part is going in a turbo car including the EJ25D , effectively un-turboing the turbocar

fyi : turbocar broke :

-
the orange thing at the bottom of the seccond pic is simply the connector where it clips to the harness , both wire , no hoses except for the top two that are in the FSM picture #1-#2

[massdrewski]

yea. On my 98GT I have a hole where that part should be connected, but it is not. Here is something.....Mine is a 5speed. Is yours an auto?

[N1446]

ding :smt023 you got it
the car the engine is from is Auto indeed
the car it is going into is a turbo 5mt chassi
never even thought it