geoacuraisuzu
07-23-2009, 05:34 AM
I have a 92 legacy and I also have 2 EG33's one is in my SVX and the other is sitting in a chair in my living room, I'm ripping down and going to rebuild it. Now my stupid question is how the heck do I get the block apart to change the crankshaft bearings? I already undid all the bolts that holds the two sides of the block together, so I can move them, but do I need to unbolt the con-rod bearings and then pull the block apart? I'm new to Subaru like I put in the title so I'm at my learning wall, I don't put not curve because the motors are so different from building a typical motor.