I was looking into rebuild upgrade ideas for my BG, which is leaking from at least 1 fitting. I came across the following ratio info over on Nabisco.
BG Outback 19:1
Gen2 Legacy/non-outback 16.5:1
WRX 16.5:1
Gen1 Legacy 16:1
STI 15:1
Legacy STI S402 13:1
Goodluck finding the S402 jdm unit, so thats out of the question.
The STI & WRX units require the xmember, endlinks, steer shaft and maybe more. So I'm not going that route.
The Gen1 Legacy has been tried and is not a straight bolt up, due to the endlinks being the wrong length.
So I'm considering a Gen2 Legacy swap. Has anyone tried this?