I installed some projectors along with some hid's in my second gen legacy and they've never seemed to work properly. Wondering if anyone else has had an issue with their hid/projector setup. I bought some ddm tuning hid's and they worked for a couple weeks with no problems, then they started flickering from time to time, after about another week the pass side one would just shut off after a small amount of driving. It was winter at the time so I never got around to looking into this and just now I went in to have a look and see if i could see anything wrong. Well I noticed the seal in the plug from the ballast to the light bulb hadn't been sealing properly and was full of corrosion. To the point where one of the pins actually broke off making the ballast unusable. I had a set off ballasts from my other car that i took out awhile ago so I thought I'd just swap those in and see what would happen. Now they both come on but flicker and same thing pass headlight just turns off after a bit of driving and sometimes they will both turn off but if i flash the high beams theyll both turn back on, pass side will turn off again shortly after. I'm thinking of just re soldering all my connections and making sure they are nice and clean. Does anyone have a diagram for wiring the projectors in? I just followed some tutorial on youtube so I'm thinking maybe I wired them up wrong aswell. Thanks for any help.