What have you done to your car today?

[Felipe]

Lol ok guys I won't install the spoiler

Maybe a few inches lower and probly go with it. But at the end its how you like it!

[Grimmrican]

Lol ok guys I won't install the spoiler

Maybe a few inches lower and probly go with it. But at the end its how you like it!

u know I was actually looking at it again today as I propped the spoiler on the trunk and thought "what if I shaved it down some?" Meh who knows tho

[Wiscon_Mark]

Programming is easyish in what way? I am intrigued by this....

If you have the Alpine system it's a bit tricky and take a few tries to get the car into programming mode, but it's not impossible to do at home, by yourself:

1. Unlock all doors
2. Open & Close driver's door
3. Put key in ignition
4. Rapidly switch the key back and forth between "lock" and "on" (not start, and don't pull the key out) 10 times within 15 seconds. You must do so rapidly, it may not work the 1st time.
5. Open & Close driver's door. The horn should honk once to indicate you're in programming mode
6. Hit any functional key (say lock or unlock) on the remote you wish to program. Horn will honk twice to indicate successful programming. You can program any additional remotes (up to 4 total) at this time.
7. Remove key from ignition to end programming mode. Horn should honk 3 times.

Cars101.com has these instructions too, but I found my experience varied slightly. Just make sure you fire the key rapidly back and forth quickly, and it'll work.

Note: This is for the Alpine keyless system found in Subarus between '99 and '04 (rounded edges fob, not the square old fob).

[Felipe]

Lol ok guys I won't install the spoiler

Maybe a few inches lower and probly go with it. But at the end its how you like it!

u know I was actually looking at it again today as I propped the spoiler on the trunk and thought "what if I shaved it down some?" Meh who knows tho

Photoshop?

[Muse]

Lol ok guys I won't install the spoiler

Maybe a few inches lower and probly go with it. But at the end its how you like it!

u know I was actually looking at it again today as I propped the spoiler on the trunk and thought "what if I shaved it down some?" Meh who knows tho

Photoshop?

Potatoshop always knows...

[Grimmrican]

My laptop that had my expensive photoshop cs8 decided to poop all over the bed, room, walls, windows, it's everywhere. So no ps for me. Unless someone would like to do so for me that would be awesome too lol

[grayguy]

I plasti dipped my L7 grill black last night to get rid of the peeling fake chrome look. HUGE improvement.

[rkrenicki]

I swapped my 95 legacy RSB into my wife's 03 OBS. straight swap and went from 13mm to 15mm.

BUT this also means you could swap in a gen 1 OB RSB and go to 18mm!!

I am a bit confused by this post..

So, the 2nd gen Legacy RSB fits into an 03 Impreza Outback (Outback Sport?)? Or an 03 Outback Sedan (BE)? And by Gen 1 OB, you mean a 96-99?.. aka an outback trimmed 2nd Gen Legacy?

Gah, I hate all these inconsistent acronyms and generation designations that have creeped into the internets..

[86bratman]

I swapped my 95 legacy RSB into my wife's 03 OBS. straight swap and went from 13mm to 15mm.

BUT this also means you could swap in a gen 1 OB RSB and go to 18mm!!

I am a bit confused by this post..

So, the 2nd gen Legacy RSB fits into an 03 Impreza Outback (Outback Sport?)? Or an 03 Outback Sedan (BE)? And by Gen 1 OB, you mean a 96-99?.. aka an outback trimmed 2nd Gen Legacy?

Gah, I hate all these inconsistent acronyms and generation designations that have creeped into the internets..

96-99 Legacy Outback rsb will fit 92-99 Legacy's that originally had a rsb with no modification, will need lateral links swapped if it's a non-rsb car originally. The same is also true for 93-07 Impreza.

Sent from my HTCONE using Tapatalk

[pleaidestar]

Went to the u pull today, got a 98 ob rsb 4 infinity components and corners for my 1st gen, and I peeped a 91 xt with the 2.7 h6....imagined it in my first gen and looked at my wallet..then the date...then looked at my wallet again sadly..little voice in my head said "your rents due mutha f***a"....so I kicked rocks..

[Wiscon_Mark]

I swapped my 95 legacy RSB into my wife's 03 OBS. straight swap and went from 13mm to 15mm.

BUT this also means you could swap in a gen 1 OB RSB and go to 18mm!!

I am a bit confused by this post..

So, the 2nd gen Legacy RSB fits into an 03 Impreza Outback (Outback Sport?)? Or an 03 Outback Sedan (BE)? And by Gen 1 OB, you mean a 96-99?.. aka an outback trimmed 2nd Gen Legacy?

Gah, I hate all these inconsistent acronyms and generation designations that have creeped into the internets..

The rear suspension on the GD (02-07) Impreza is very similar to the BD (95-99) Legacy. He swapped his 15mm bar from his Legacy onto an 03 Impreza. His deduction was that since an 18mm outback bar is an upgrade for the Legacy, you could put an 18mm Outback (BG) bar on a GD Impreza. Plenty more WRX bars are available from that chassis though, since so many WRX owners upgrade. It would probably be easier to get a WRX bar. Not sure exactly what size they are, but they must be similar.

The 03 Legacy (BE) has a completely different rear suspension from the others, it wouldn't work.

[superu]

Yeah you got it.
95-99 legacy rear sway bar fits into an 03 OBS (and I assume by extrapolation, 00-07 Imprezas).

I swapped a 95 legacy sedan bar into an 03 OBS wagon and since I swapped a 98 legacy OB wagon bar into that 95 legacy sedan, I assume it would also go into the OBS too.


While I admit I don't know them all, body codes are more accurate in these situations. :smt002

I swapped my 95 legacy RSB into my wife's 03 OBS. straight swap and went from 13mm to 15mm.

BUT this also means you could swap in a gen 1 OB RSB and go to 18mm!!

I am a bit confused by this post..

So, the 2nd gen Legacy RSB fits into an 03 Impreza Outback (Outback Sport?)? Or an 03 Outback Sedan (BE)? And by Gen 1 OB, you mean a 96-99?.. aka an outback trimmed 2nd Gen Legacy?

Gah, I hate all these inconsistent acronyms and generation designations that have creeped into the internets..

[Dead91silvia]

GT-B died about 4 miles from home... Fuel pump took a dump... Had an Outback one chilling in the shed... Took an hour to fix. Good to go now.

[thenines']

Have a take off mid-pipe and muffler from a FRS-need to see if the muffler could be made to fit the '91 FWD sedan

[Muse]

Have a take off mid-pipe and muffler from a FRS-need to see if the muffler could be made to fit the '91 FWD sedan

... Cool.

[Grimmrican]

Rkrenicki and I did our first timing job and we were successful

[Thomistopheles]

Got my new exhaust made on friday.

[Wiscon_Mark]

Aaaaaand?

What is it? Do you like it? What does it sound like?

Your post is useless with pictures!

Joking, your Outback looks great.

[Navi271]

^lol

Replaced all 3 gaskets for the exhaust manifold. One of them was leaking badly, and one of the bolts was loose as well.
Now there's much less noise coming from up front, and more out of the rear!

[Grimmrican]

Today I took away my spare keys to my car and handed my gf her own damn car keys as now her Bh is running. Was a win-win scenario

[grayguy]

Today I finally did the rear brakes on my car. Between that I plasti dipped my LGT 17" 5spokes with 3 coats of "anthrite true metallic" and 2 coats of glossifier. I LOVE the color, but I decided I like the style/fitment of the rotas better so I will be ordering more Dip and dipping them. Here is how she looks, don't mind the filthy car haha

[Thomistopheles]

Aaaaaand?

What is it? Do you like it? What does it sound like?

Your post is useless with pictures!

Joking, your Outback looks great.

2.25", 20" thrush glasspack, magnaflow xl3 muffler. I like it. It sounds like BRRR-R-R-R-R-R-R-R-R-R-R-R-RRRMMMM.

You'll just have to come down and drive it sometime. muahahahaha

[superu]

Rear Sway Bar (RSB) quick disconnect






Two 14mm wrenchs and a 15mm wrench (leverage arm on one 14mm), PB, 3/8" by 2" clevis pin and "R"clip
Best $2.73 mod for awesome off-road articulation!!!
(I'd already gotten the other side on when I thought about the camera, thus only one clevis set-up in the pic

[superu]

HAHA, ThisPostIsWorthlessWith)Pictures

Yeah add the vid dood, vid up!

But also to support your set-up. . .
Its about the same as mine. I'm 2.25" cat-back (cats keep the requisite back pressure) through a 12" glasspack (as resonator) and a magnaflow (not sure its specs). Great deep rumble but not loud even at revs. I bet your 20" glasspack and EJ25 make it a scosh deeper than my EJ22.


click me --> <-- click me

Aaaaaand?

What is it? Do you like it? What does it sound like?

Your post is useless with pictures!

Joking, your Outback looks great.

2.25", 20" thrush glasspack, magnaflow xl3 muffler. I like it. It sounds like BRRR-R-R-R-R-R-R-R-R-R-R-R-RRRMMMM.

You'll just have to come down and drive it sometime. muahahahaha

[Grimmrican]

Rear Sway Bar (RSB) quick disconnect

https://lh4.googleusercontent.com/-EZ_J ... .JPG?gl=US
https://lh4.googleusercontent.com/-r0aO ... .JPG?gl=US
https://lh6.googleusercontent.com/-3h2S ... .JPG?gl=US
https://lh3.googleusercontent.com/-L-QK ... .JPG?gl=US

Two 14mm wrenchs and a 15mm wrench (leverage arm on one 14mm), PB, 3/8" by 2" clevis pin and "R"clip
Best $2.73 mod for awesome off-road articulation!!!

dude ur a freaking genius lol this would be a good idea for my FSB since the rears wont be able to do this. thanx for the idea

[ElbryanWolf]

Car is off to the Spa for an in/out wash + mag cleaning + armor all

First time I try these guys, hoping for a good job

Cheers!

(pictures to come later)

[thenines']

Got new tires put on and a much needed alignment-put the car up on the lift at work to see if the FRS muffer would fit-nope got around to checking my oil-bearly registered on the dipstick (dopeslap!) I'll change it after I get back from Vermont.

[iampetro]

Took the wagon Camping and took a few pics




Decided to take a couple more shots of my new grill

[98legwag]

Washed it. Then hit it with Mother's California Gold Pure Polish, Mother's California Gold Sealer/Glaze, and finally Collinite 476. It looks like a shiny blue mirror. Or at least as much of one as I can make it. Of course it was dark out by the time I finished.

[1055]