clutch not engaging all the way

[prodriver1]

hallo, my 98' outback is having trouble, it is slipping in first, it will engage (sort of) and the car will roll forward but if i give it any amount of gas it just slips, the clutch is fine, i just put a different engine in from my other outback, I replaced the slave cylinder as it was a little rough when I played with the piston in it, but that didnt help, I am going to pull the engine again and check if i got oil on the clutch plate or something, just wondering if anyone had and solved this problem. cheers lads.

[nepbug]

Assuming there is no oil leak problem and there is adequate clutch friction material left, I think it might be a pressure plate issue. I'd double-check all the bolts are tight and that nothing has broken on that.

Did you transfer the flywheel from the other engine over to this one?

[prodriver1]

thanks for the reply dude! I just pulled the engine to check it out as its a cake walk pulling non-turbo subaru engines out, I did it in 50min this time anywho it was the stupid little wire clip thingy that holds the TO bearing to the fork lol, i made a vid of it on my youtubes account (prodriver33) it snapped of and the TO bearing got stuck in front of the Ti sleeve I have on the trans snout, I'm running a toyota taco TO bearing due to the change so I need to go to napa and get another clip or just make one out of an old coat hanger, I usually MAcGyver shit like that lol, the car cost me $500 about 6-7 years ago and other than mods I have spent less than that keeping it on the road.