Results 1 to 4 of 4

Thread: Scary drive warrants front end rebuild

  1. #1
    Drama Queen 2.0
    Join Date
    Apr 2005
    Location
    Not here! :-)
    Posts
    611
    Points
    9,856
    Level
    66
    Points: 9,856, Level: 66
    Level completed: 52%, Points required for next Level: 194
    Achievements:
    5000 Experience PointsO.G.

    Scary drive warrants front end rebuild

    I drove my 93 sedan on the highway the other day and noticed that when a gust of wind or a larger vehicle passed me, my vehicle would tend to wonder from side to side. I coould be holding the steeringwheel dead straight and it would wonder.

    It was at this time that I decided if I made it back home I would replace the following:

    (2) outer tierods
    (2) inner tierods
    (2) balljoints

    and a super tune-up.

    anybody want to add to this??

  2. #2
    t3h ch33se Wiscon_Mark's Avatar
    Join Date
    May 2005
    Location
    Plover, WI
    Posts
    9,857
    Points
    43,397
    Level
    100
    Points: 43,397, Level: 100
    Level completed: 0%, Points required for next Level: 0
    Achievements:
    25000 Experience PointsO.G.Overdrive
    get it balanced and aligned?

    I mean, it wouldn't directly cause this, but it could have something to do with it...
    ~Mark [SLi Admin]
    2015 Dodge Charger AWD
    2008 Subaru Tribeca Limited, 7 passenger w/ Navigation

    Former vehicles:
    03 Forester
    95 Legacy Outback

  3. #3
    SLi Resident
    Join Date
    Jun 2005
    Location
    San Jose, "The Capital of Silicon Valley"
    Posts
    609
    Points
    9,043
    Level
    63
    Points: 9,043, Level: 63
    Level completed: 98%, Points required for next Level: 7
    Achievements:
    5000 Experience PointsO.G.
    although throwing parts is never bad, it could get expensive. Check your wheel bearings by lifting up the front end and wiggling the wheels back and forth, they shouldnt move. If one does, then the bearings are quietly dying. Also climb under the car and look at the steering rack mounts as someone wiggles the steering wheel back and forth about 1 inch either side of center. If the rack is moving, even a tiny bit, in the mounts, then you need to either tighten them or replace them with some really wonderful PU steering rack bushings. Tie rods can be checked with the same wiggle method.

    I'm pretty sure that replacing all the tierods and balljoints will be more expensive than getting a late model used rack from a jy.
    1990 subaru legacy- i miss you!
    1999 outback 30th deluxe deluxe megafantastic orgasmmobile

    subaru has more R&D money than the aftermarket.

  4. #4
    Drama Queen 2.0
    Join Date
    Apr 2005
    Location
    Not here! :-)
    Posts
    611
    Points
    9,856
    Level
    66
    Points: 9,856, Level: 66
    Level completed: 52%, Points required for next Level: 194
    Achievements:
    5000 Experience PointsO.G.
    I already purchased the outer tierods and the ball joints from ebay. I bought the inner tierods from the local parts store.

    Here is the breakdown:

    outer tierods and balljoints: 96.00 shipped

    Inner tierods: 41.00

    Allignment: 45.00

    The tires are like new and were just rotated and balanced when I put them onto the sedan from the wagon.

    Lets just say that I am not looking forward to installing these parts but when the ebay parts get here I will have no choice as I will be driving 100 miles round trip soon......on a daily basis.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •