PDA

View Full Version : crank pulley instal?


ScaryFatKidGT
10-09-2008, 08:55 PM
so i got every thing on im 90% sure the key is in the pulley correctly but...

how do u tighten it back down/stop the engine from turning

the DIY said something about the tourqe converter cap housing thing but that was on a 2002 i cant find it on my 98
Perdue
10-09-2008, 10:15 PM
should be back on the rear of the block where it meets the transmission almost directly under the throttle body. Start your motor and look under there for movement with a flashlight or whatever. Should be easy as pie to spot then...or is it easy as cake? Brownies even?
decke48
10-10-2008, 12:45 AM
if you looking at the TB it down to the left it look for a rubber cap/gromet
ScaryFatKidGT
10-10-2008, 02:22 AM
ok and u just like stick a bar or something in there
Huffer
10-10-2008, 07:28 AM
Flathead screwdriver, get someone to hold it.
impreza_GC8
10-10-2008, 11:19 AM
Is this only for automatics? I used some bigass clamps when did mine and wedged a screwdriver somewhere on the front side of the bock but it would've been nice if there was a better way.
decke48
10-10-2008, 11:55 AM
i think the manual have the access to. but ive never botherd to look. so i could be wrong
subba
10-10-2008, 04:43 PM
if its a M/T

put it in 5th gear and have someone press on the brakes?
ScaryFatKidGT
10-10-2008, 04:52 PM
You can do it on a MT or AT but as subba said in a MT u just put it in gear. In a AT like mine u cant put it in gear with out starting it
ScaryFatKidGT
10-11-2008, 02:58 AM
thx for the help i got it on